Forums
-
DTF Printing (Direct to Film)
-
- 2.7k
- posts
-
- 23
- posts
-
- Epson 7600
- By roni,
-
- 39
- posts
-
- 812
- posts
-
- 413
- posts
-
- 23
- posts
-
- 91
- posts
-
- 325
- posts
-
- 126
- posts
-
-
General Forum
-
DIY DTG Building
-
- 17.4k
- posts
-
-
Latest Posts
-
Thanks again for ur help..u guess ill just take a shot and get the 7500 and get it flushed and ready for when the time comes a driver rolls out...the opportunity is too good not to take it. -
It’s basically what I am doing too. I asked again and yesterday they said not yet. I asked over a month ago and they were working on it then. in the past they could get a driver out in a week or two, going on 7 weeks or so since I asked and they had already started, I’m just hoping they get them out before they discontinue the model. -
Thanks for the update. I guess ill just have to wait and stick to my p6000 until good news arrive
-
Then yeah you are good in that aspect. So all you are waiting for is a RIP to support it. The USA P6000's you had to swap the mainboard with another board from like EU or China in order for the resets to work. Same with the 7500. I reached out to everyone I could think of, the only one that was working on it was Cadlink, however they were pretty adamant on " not making new drivers" for the foreseeable future so if the one they are working on ever gets finished is up in the air.
-
I assume its the same we have with the p6000...im in europe and can use resetters without a problem but read that the us version shuts down after several resets. We will just have to wait and hope for dtf support i guess...
-
-
Forum Statistics
-
Total Topics2.8k
-
Total Posts22.8k
-
-
Member Statistics
-
Recently Added to the Gallery
